Home Network Community > All Threads > How to Setup 2 EAP's
< All Threads

How to Setup 2 EAP's

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to Setup 2 EAP's

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to Setup 2 EAP's
How to Setup 2 EAP's
2020-11-28 02:41:45
Model: EAP225-Wall  
Hardware Version: V3
Firmware Version: 202006

Hello,

 

I just purchased a EAP225 for the Living Room and EAP225-Wall for Basement.

They are both plugged in to same switch but I am trying to make sure I can roam from Living Room, which is upstairs, to Basement.

Do I give both EAP's the same SSID and Password?

 

Also on each EAP do I set the SSID and EAP for 2.4 and 5Ghz to the same?

 

Thanks in advance.

  0      
 
  0      
 
#1
Options
1 Reply
Re:How to Setup 2 EAP's
2020-12-01 23:43:19

@Super7 

 

If you want one network to connect then, then yes you would set them all to the same SSID. The roaming aspect will depend on your device itself so you may not get the desired results. 

 

I would probably make the 2.4G and 5G names different so you know exactly what you are connecting to. However, in your case make all the network names the same, and see how your devices respond, they make work fine like that. If you notice the signal being weak or if you are getting constant drops while it switched to another network, make all the names different to force the device to stay connected to a particular device/network.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 780

Replies: 1

Related Articles
EAP225
722 0
Hep with Deco BE75 2 mesh setup
133 0
Setup of 2 WiFi network using 5G and 2.4
704 0
Connect AX600 to Starlink 2
2752 0
2 ISP, 2 deco network, 1 house
484 0
DECO BE63 2 devices on same network?
1123 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.