Home Network Community > All Threads > Cannot log into router after switching to client mode
< All Threads

Cannot log into router after switching to client mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Cannot log into router after switching to client mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cannot log into router after switching to client mode
Cannot log into router after switching to client mode
2019-08-02 23:07:24
Model: TL-WR902AC  
Hardware Version:
Firmware Version: 3

I was able to log into the router with the switch in Share ETH mode.  I moved the Mode switch to External Client am not able to log into the router to set it up for client sharing.  Instead, I get the message that not connected to the TP Link network.

I moved the mode switch back to Share ETH and can log back in.  However I can not set up Client mode from this log in.

Any advice is greatly appreciated.

  0      
 
  0      
 
#1
Options
3 Reply
Re:Cannot log into router after switching to client mode
2019-08-02 23:57:23

@BobW 

 

 

Bob, when the router is put into client mode it is actually acting as an adapter and would not have an IP address and the DHCP is disabled.  To log into the router in client mode you will need to either hard reset it back to default or set a static IP/gateway to your computer's ethernet adapter and attempt to log in.  By far the easiest way to do this is to hard reset and log into the defaults.  

 

 

Best Regards

Check out the Latest: Recent Smart Home Features and Updates for Tapo and Kasa Securing Your TP-Link ID with 2FA:Deco and Tether | Smart Home Splash into a Smarter Summer with Sub-G Sensors, Matter, and Apple Home!
  0  
  0  
#2
Options
Re:Cannot log into router after switching to client mode
2019-08-03 00:14:31

Thanks, Carl.  Please excuse me.  Could you clarify.  Are you saying that if I do a hard reset, I should be able to log into the router and set up ext client parameters with the mode switch in the share eth position.

 

Thanks

  0  
  0  
#3
Options
Re:Re:Cannot log into router after switching to client mode
2019-08-03 13:40:20

Carl, I did resolve the issue.  I found that I needed to put the router mode switch in the Share Hotspot position, do a hard reset and was able to properly configure my client connection.  Thank you for your advice.  All is good.

 

Regards,

Bob

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 2088

Replies: 3

Related Articles
Client Log
94 0
can't log onto router network
397 0
You cannot log in to this router since you are not a manager of it.
1750 0
Switching from old router to new AX6000
1119 0
Client list gone after switching to ap mode
72 0
How do I log into my router
1999 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.