Accessing control panel with DHCP disabled

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Accessing control panel with DHCP disabled

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

khoi

2017-01-28 12:35:15

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2017-01-28

Accessing control panel with DHCP disabled

2017-01-28 12:35:15

Model :

Hardware Version :

Firmware Version :

ISP :

Hi, I've set up my Archer C7 to route wifi traffic only. It's hooked up over LAN to another router than handles the WAN traffic.

Everything works great except that in this configuration I can no longer access the C7's control panel.

I've identified it as having the IP address 10.0.1.108 in this configuration but entering that into my browser doesn't call up the control panel. Neither does entering tplinkwifi.net.

Any tips would be greatly appreciated.

1 Reply

R1D2

LV6

2017-01-30 06:56:56

Posts: 4334

Helpful: 1039

Solutions: 173

Stories: 3

Registered: 2015-12-05

Re:Accessing control panel with DHCP disabled

2017-01-30 06:56:56

How did you discover that it has the IP 10.0.1.108? Did you define this IP in LAN settings of the C7 as it's address?

To be sure, check wether you can reach it under it's factory default 192.168.0.1 or 192.168.1.1. To do so, set your PC to a free static IP in the same subnet, e.g. 192.168.0.10 (or 192.168.1.10), connect it to the C7 directly and try to load the web UI using one of the mentioned IPs. If successful, change it's LAN IP to some free IP out of the 10.0.1.0 subnet your another router (which handles LAN/WAN) uses.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻

Accessing control panel with DHCP disabled

Accessing control panel with DHCP disabled

Information

Voters 0

Tags