Home Network Community > Wi-Fi Routers > Accessing the control screens while in Access Point mode
< Wi-Fi Routers

Accessing the control screens while in Access Point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Accessing the control screens while in Access Point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Accessing the control screens while in Access Point mode
Accessing the control screens while in Access Point mode
2022-03-10 20:03:28
Model: Archer A7  
Hardware Version:
Firmware Version:

Got the router set to access point mode, but I am unable to access the control screens using a browser.  One thing I can say is, it does function as an access point.  I just can't change anything.

 

Hope some one has an answer, or this is going back to Amazon.

Thanks.

Rick

  0      
 
  0      
 
#1
Options
2 Reply
Re:Accessing the control screens while in Access Point mode
2022-03-11 07:30:13

Hello @ricknbeachcrest,

 

When trying to access the web GUI of the Access Point, please be sure A7 is connected to the host router with an Ethernet cable, then try accessing its web GUI via http://tplinkwifi.net.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options
Re:Accessing the control screens while in Access Point mode
2022-03-11 15:31:13
OK, I did as you suggested. And it worked. So maybe you can answer this for me? Before changing the mode to AP, I set the IP address to 192.168.1.3 When in AP mode, the IP address is 192.168.1.157 When I put this address into the browser, it goes right to the AP's GUI. Is the AP getting its IP address from the router (DHCP)? And I'm guessing that by using tplinkwifi.net , that the browser is going to tplink and then redirected to my GUI for the AP? I appreciate the help. Thanks. Rick
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 613

Replies: 2

Related Articles
 Accessing USB
412 0
 Accessing control panel with DHCP disabled
5454 0
 Accessing Wired Devices
373 0
 Accessing USB Drive
738 0
 Accessing url on Wifi
525 0
 Accessing Network Devices
451 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.