AX3000 / WA-3001 Multi SSiD mode SSID isolation
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP Link, does the AX3000 / WA-3001 Access Point automatically isolate SSIDs when in Multi SSID Mode? Is there any way to turn this off? I am not able to communicate between VLANS assigned to different SSIDs and I would like to be able to so I can handle the access at the Firewall.
If your router/firewall supports VLANs then you should be able to handle the access at its level:
On the other hand you can change the SSIDs VLAN setting by clicking the edit button in Wireless=>Wireless settings:
and set them the same if you want to.
@terziyski Thanks for the reply! My Firewall/Router does handle VLANS and the default is allow all traffic between VLANS per the manufacturer. I have them mapped in the AP as you noted, one VLAN for each SSID to provide segmentation. For example, I have VLAN 11 configured to SSID NAM_Main and my phone connected with the IP of 192.168.11.135 and a VLAN 88 configured to SSID NAM_IoT with the IP of 192.168.88.126 but I cannot connect to the Chromecast. If I connect the phone to NAM_IoT, I can connect to the Chromecast! This is why I am asking about SSID isolation. Below is a network diagram.
I really can't say how this is implemented in the TL-WA3001 FW. Probably a TP-Link representative should elaborate on this one.
I noticed one port label in your network diagram though:
According to your TL-SG108E configuration this should be Port 5 if I am not mistaken.