TL-WR902AC- Set Up WiFi Network with a single device plugged into the ethernet port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-WR902AC- Set Up WiFi Network with a single device plugged into the ethernet port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WR902AC- Set Up WiFi Network with a single device plugged into the ethernet port
TL-WR902AC- Set Up WiFi Network with a single device plugged into the ethernet port
2021-10-06 12:18:38 - last edited 2021-10-08 01:52:33
Model: TL-WR902AC  
Hardware Version:
Firmware Version:

So I want a single device plugged into the ethernet port and then a number of wifi devices to all be on the same network. How do you set this up? Thanks

  0      
  0      
#1
Options
1 Reply
Re:TL-WR902AC- Set Up WiFi Network with a single device plugged into the ethernet port
2021-10-11 11:47:15

@oguy 

 

What you are describing is what a wireless router does, WR902AC can be set up as a wireless router, go through the following guide you will have a wireless network for a number of devices:

https://www.tp-link.com/support/faq/2028/

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options