@Yannie Hello, to update, i simply went back into the config and checked the channel was still set to 100 DFS (which is was), despite showing 48 in the AP table and scan. I just simply pressed apply...

I have 3 of these AP's and i've attempted to configure them on seperate channels for the 80mhz width option. Therefore, channels configured are (I'm in UK) Floor 1: 36 Floor 2: 100 Floor 3: 52 I have...

Thank you, good point about water ingress on the port. I shall stick with the correct orientation.

@fsv Even though there are no other access points nearby, that doesn't mean other devices on your network aren't affecting your speed testing. When i tested my network with iperf3 any other wirelss...

As the title says, is it ok to mount this upside down? The way this will be wired, with cat6, the connector is underneath the unit and the wire will come from above. The question is regards to the...

@R1D2 Thanks, very informative. I agree about trying to find the middle ground. It is probably best that i try to set something up with the least amount of user input or config. Users are always the...