@MR.S No Omada Switch and no router. And i dont understand why you talk me about router. If equipment are in the same VLAN, why do you need router ?????

@MR.S OC200-ETH1 is connected to a Cisco SG250-8 on port 8 in Acces Mode Untagged in VLAN 66 Cisco Switch port 1 is connected on Infra in Trunk Mode (without VLAN 1, not needed) EAP225 is connected...

@Clive_A I dont understand the logic of tplink configuration, but this is my config. Omada OC200 port 1 is connected on cisco switch on untagged port in VLAN 66. If put on an another port untagged in...

Hi. I have a problem with my configuration. In the network configuration "default site/parameters/wired network/Lan" i cannot setup Tagged/Untagged parameter. I explain. My management VLAN as ID 66...

@btx Perhaps, but it was more than 2 year old, and i doubt that i can RMA it. Concerning the oc200 (a normal unit) itself it works, it was little and i can put it in my network bay. I'm going to...

Thanks Virgo, i'm not a newbie in IT (dont be offenced). Generally, before i post for help i've tried all the forum/internet solution i can find on intyernet and on this forum. I have tried to...