R1D2 wrote jonas wrote I think it works. You can write down the Hostname or IP address of Omada Controller in Discovery Utility. Since the Omada Controller is at the back of the NAT Router, the...

Cajuba wrote As my ISP does not provide a static IP for the Controller host location's network I have to use a DDNS URL. Will the Discovery Utility accept the Controller's URL instead of an static IP...

Questionmark wrote @forrest, Unless I am missing some important detail, something doesn't look right here. The point of using 'auto' should be to let capable clients use WPA2-PSK while still allowing...

sportq wrote I have a question about EAP 245 VLAN handling on the passthrough port. My config has has 3 SSID's on 3 separate VLAN's. The access point is connected to a TL-SG2210P smart POE switch....

Note: This article applies to Omada Controller. Silent installation allows you to define an installation configuration only once and then use this configuration to install Omada Controller on all...

rene.fennet@gm wrote Model : EAP115 Hardware Version : V2 Firmware Version : 2.0.0 Build 20171011 Rel. 61847(4555) ISP : Good day all, I am the proud owner of a pair of EAP115 V2 . Last update of the...