@pcsurgeon Once the gateway shows up as "configuring," it should be editable. You might be going too slow or fast.

@pcsurgeon Configure the gateway in stand-alone mode with the correct subnet. Back up gateway settings. Adopt the gateway... While it is configuring, quickly go to Settings > Wired Networks > LAN >...

@Fae This process does not work if you're using a software controller that's on the original network, especially if it's in a docker container with a static IP. I've come up with a different...

I completely disconnected my whole TP-Link network and hooked up an old router to get access to port 80 for LetsEncrypt validation. The WAN assigned new DHCP addresses and when I hooked things back...

@Livonias This also makes it impossible to forward port 80 with a virtual server. It's absolutely inappropriate and needs to be fixed.

The TL-R605, which is being managed by my Omada software controller, is serving up a config page on port 80. Not only is this a huge security flaw, but it's likely interfering with authentication for...