PhilbertLV5Online
Following: 2Followers: 14
Forums/ Deco
2023-10-14 11:12:16
Re:Deco X50-5G (1.0) DDNS and two public adresses
@rusms It sounds like your ISP / cell provider is running Carrier Grade NAT (CGNAT) that would explain your strange IPs The Deco is picking up its IP from your ISP as 10.123.123.250 which is an...
1HELPFULS
Forums/ Deco
2023-10-14 10:59:35
Re:i have 6 dexo x20, i plan to add another 3 deco in the same network
@zcx The 6 rule is more for Deco devices connected wirelessly, once you pass 6 it's a case of greatly diminishing returns due to the traffic going over the air. However if you are running these via...
3HELPFULS
Forums/ Deco
2023-10-14 10:55:42
Re:Deco XE75 limited speed to 94Mps
@MK6 94mbps is a very specific number and is usually a sign that the cable connected to the LAN is running at 100mbps and not 1000mbps. I would check / replace the cable between your ISP modem and...
1HELPFULS
Forums/ Deco
2023-10-14 10:53:56
Re:How many ethernet ports are usable on the slave x60?
@JosepPC95 Short answer is that Deco can use both ports for either purpose, therefore YES you can connect 2 devices into the slave Deco. If you need more ports, a small 4/5 port switch would also...
2HELPFULS
Forums/ Deco
2023-10-14 10:52:32
Re:Bad connection and signal after update
@SNap890 You could try running the network optimiser from the App. This will check and change the WiFi channel if required and may help overcome the signal issue
0HELPFULS
Forums/ WiFi
2023-10-14 10:39:08
Re:HELP - Convert EAP655-Wall(EU) v1.0 to EAP655-Wall(US)
@mur77 Ah learn something new every day, genuinely wasn't aware that you could change the firmware region. Suppose then again its not something I have ever needed or thought to do.
0HELPFULS
1131415...