Door bell hub just keeps ringing
After a recent firmware update, my TP Link hub just keeps ringing for over 2 minutes, even though I set 10 seconds, 5 seconds time
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@freakygs found the solution -- go to your doorbell settings > Paired Chimes > select your hub > change the duration. Hope this helps!
- Copy Link
- Report Inappropriate Content
@freakygs found the solution -- go to your doorbell settings > Paired Chimes > select your hub > change the duration. Hope this helps!
- Copy Link
- Report Inappropriate Content
@Ollieoos , yes it did resolve the issue. Thanks mate.
Kinda poor design having to setup chime duration at 2 places.
- Copy Link
- Report Inappropriate Content
Thanks. Came here for this exact problem.
Only since the latest firmware update.
Set duration to same as ringtone now.
Now working for me
Would have been good if Tapo gave a notification along with firmware of this change.
- Copy Link
- Report Inappropriate Content
also had this issue AND the chime set to jingle bells, so it blasted jingle bells at full volume in february for 1 minute. very unhappy with this change, why force additional settings layers on us AND not even inform the user!??
- Copy Link
- Report Inappropriate Content
@Ollieoos hi where is paired chimes ? My model is D230 of doorbell. I have same issue mentioned here.
- Copy Link
- Report Inappropriate Content
I had the same issue
This is the solution that worked for me.
Just after the installation of the hub you set your desired ringing time.
Only after that you install the doorbell.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 4
Views: 570
Replies: 7
Voters 1
