D235 doorbell showing solid orange but not resetting when pressing the reset button
Just installed new tapo d235 doorbell in hardwired mode yesterday. After 15 hours doorbell is offline in the app. I tried resetting by pressing reset for 10 seconds but nothing happens like and its still solid orange. Tried powering it on but not responding.
The wifi network used is working perfectly fine with internet on other devices. I didn't change any dns or internet settings on the router/modem
What's the solution?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Try the suggestions provided above in the FAQ for the smart device remote control failure issue. If it doesn't help, tell us what steps you've tried.
- Copy Link
- Report Inappropriate Content
Wayne-TP wrote
Does the doorbell LED show any changes when you reset it? For example, blinking red quickly?
To reset the Tapo D235: Press and hold the SYNC/RESET button for 5 seconds.
Yes is start to blinking red for about 10 seconds. like descibed in the docuemation. but afterwards is moving back to be registered and goiing back into the circle of red, amber, White every minute. I had also removed it from the app and reset again on the device, same behavior. Device seems to not really reset as its comming also back to the app.
Support was also unsure what todo and asked for sending back. thats what I have started now. it goiing back to TP-Link.
- Copy Link
- Report Inappropriate Content
No, goes to solid blue. No is disconnected from the Cloud/app again, and it has to be turned off/on again. All other cams that loose connections to cloud are able to connect without turning off/on.
- Copy Link
- Report Inappropriate Content
Do you have a video? This led change does not seem normal. And if a factory reset does not help, then replacement is needed indeed.
- Copy Link
- Report Inappropriate Content
billsob wrote
No, goes to solid blue. No is disconnected from the Cloud/app again, and it has to be turned off/on again. All other cams that loose connections to cloud are able to connect without turning off/on.
As mentioned, for the cloud disconnection issue, please try to suggestions in this article. What should I do if I can't view the Tapo camera?
If it doesn't help, contact the support team with relevant details for further assistance.
- Copy Link
- Report Inappropriate Content
Yes, its not normal, and this is already a new device that have been replaced, and now with the same "failure" as the one before.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 19
Views: 1972
Replies: 36
Voters 1