TP-LINK Tapo T300
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am reading that the T300 Leak Sensor has a 90db alarm.
I have an existing automation in place where if a sensor/camera picks up motion, then the hub’s alarm is triggered.
Can I add to this automation the T300 alarm (i.e. if motion is detected then hub alarm goes off plus T300 alarm goes off)?
Thank you.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
T300's alarm only gets triggered when this is a water leak. It's not a dedicated alarm device like the Tapo hub.
- Copy Link
- Report Inappropriate Content
That's what the Tapo hub can do. It's not only a controller for Tapo Sub-G devices but can also work as an alarm device. Tapo H100 and H200 are sold separately in some areas, so consider adding multiple hubs if you have a need to install alarm in multiple locations.
- Copy Link
- Report Inappropriate Content
What do you need it for? I don't see the necessity to disable a water leak sensor's alarm by a movement. Please describe in detail the reasons and scenarios based on which you proposed this feature request?
- Copy Link
- Report Inappropriate Content
Thank you. The hub is located next to router in the living room. If motion is detected by the sensors or the cameras and the alarm is triggered, I also need a siren to go off in the kitchen, which is away from the living room (i.e. with closed doors, the hub alarm will not be loud enough in the kitchen to hopefully scare off an intruder).
- Copy Link
- Report Inappropriate Content
T300's alarm only gets triggered when this is a water leak. It's not a dedicated alarm device like the Tapo hub.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
That's what the Tapo hub can do. It's not only a controller for Tapo Sub-G devices but can also work as an alarm device. Tapo H100 and H200 are sold separately in some areas, so consider adding multiple hubs if you have a need to install alarm in multiple locations.
- Copy Link
- Report Inappropriate Content
My understanding is that the hub needs to be connected to the router via cable. If not, I will purchase a hub, pair it via wi-fi and use it as a siren.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 803
Replies: 7
Voters 0
No one has voted for it yet.