Unpair a camera from a hub

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unpair a camera from a hub

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unpair a camera from a hub
Unpair a camera from a hub
2024-01-17 10:28:51 - last edited 2024-01-26 12:55:32
Model: Tapo H200  
Hardware Version: V1
Firmware Version: 1.2.25

I have 2 x H200 hubs.

Both of my cameras are linked to the original H200 hub.

How do I unpair one camera, and pair this with the new H200 hub?

The Tapo app shows that the hub/device is linked, but does not offer a means to unpare the device from the hub.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Unpair a camera from a hub-Solution
2024-01-18 11:19:08 - last edited 2024-01-26 12:55:32

  @wNc 

Hi,
You can go to the camera's Device Settings page on the Tapo app and click on Remove Camera to reset the camera, or use the Reset button on the camera to reset it to factory default settings. After that, the camera will unpair from the original hub.
How to reset my Tapo camera?

Then you can move the camera close to the new hub Tapo H200, and try to configure it via the Tapo app to connect it to the new hub.

 

Best Regards

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Unpair a camera from a hub-Solution
2024-01-18 11:19:08 - last edited 2024-01-26 12:55:32

  @wNc 

Hi,
You can go to the camera's Device Settings page on the Tapo app and click on Remove Camera to reset the camera, or use the Reset button on the camera to reset it to factory default settings. After that, the camera will unpair from the original hub.
How to reset my Tapo camera?

Then you can move the camera close to the new hub Tapo H200, and try to configure it via the Tapo app to connect it to the new hub.

 

Best Regards

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 381

Replies: 1

Related Articles