Tapo C110 stuck in update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tapo C110 stuck in update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tapo C110 stuck in update
Tapo C110 stuck in update
2023-11-18 10:05:03
Model: Tapo C110  
Hardware Version: V2
Firmware Version: 1.3.2

The update from firmware 1.3.2 to 1.3.9 started hours ago, it is still in update mode and not reachable. The router (fritzbox) indicates, that connection to the internet are active, but I can not see what is happening. The update is running now over 2 hours, I'm sure nothing will change.

 

What can I do now?

The notification "Do NOT power off your smart device ..." is still in the android app (latest playstore version).

 

  0      
  0      
#1
Options
2 Reply
Re:Tapo C110 stuck in update
2023-11-18 10:09:10
I can not see any active LED on the device, the status LED setting was off before the update.
  0  
  0  
#2
Options
Re:Tapo C110 stuck in update
2023-11-20 11:55:50

  @Jesse22 

Hi,
Please help confirm the following information about the issue.
1. What's the MAC address of the Tapo C110?
2. Please turn it off, wait for 2 minutes, turn it back on, and wait for 10 minutes, are you able to control it via the Tapo app?
3. If not, please refer to the link below to reset the camera and check if any changes to the LED status.
How to reset my Tapo camera?

Best Regards

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 675

Replies: 2

Related Articles