This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
i have a TPlink TL R605 serving DHCP
connected via Deco M5
I have aNVR connected to the system
I have found that even i reserve the IP with mac it changes
the NVR look for IP address
so if my network restart the camera gets disconnected
i am unable to assign IP for the camera permanently
what is the solution???
Hi,
Please help confirm the following information about the problem reported.
1. Please describe your network diagram in detail.
1) Is the network diagram the internet--TL-R605--main Deco M5)))(((Satellite Deco M5)))(((Tapo C200?
2) Is the NVR connected to the main deco, satellite deco, or R605? Are the Tapo C200 and NVR connected to the same Deco?
2. Which mode(Router or AP) used on the Deco M5?
3. Do you reserve the IP address for the camera on the R605?
4. What do you mean by network restart? Such as a power outage, reboot R605, main Deco, or others?
Best Regards
Helpful: 0
Views: 321
Replies: 1
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
