Tapo L930 strip devide into 2 sections
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tapo L930 strip devide into 2 sections
In my case the led strip is installed in the kitchen.
1 part of 2,2m is installed below the worktop of a fixed part of the kitchen.
The second part of 2,2m is installed at the kitchen island with in between a 4 wire cable of 6m.
After installation the first part is working fine, but from the second part only the first section is lighting up.
Is this caused because of the high speed of the communication line, or is it needed to close the communication bus at the end with a resistor?
it is not possible to add a second adapter + strip in the kitchen island.
How can I solve this issue?
Regards,
Gette
