0
Votes

Smart action with switch as a client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
0
Votes

Smart action with switch as a client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Smart action with switch as a client
Smart action with switch as a client
2021-11-02 20:02:46 - last edited 2021-11-03 20:46:04
Model: HS200  
Hardware Version: V5
Firmware Version: 1.0.2

Currently smart action allow by turning switch on and off, to control a client device status. I need opozite action, if client device is on or off, switch should go in correspondent state as well. Also I like to see dimming support in smart actions for these scenario as well.

#1
Options
1 Accepted Solution
Re:Smart action with switch as a client-Solution
2021-11-03 02:21:58 - last edited 2021-11-03 20:46:04

Hello @Yokushka 

Currently, in a smart action, 'Control with a Switch' only allow smart switch works as the trigger , not the client device like the bulb/ plug works as the trigger, thank you for your idea, I will forward your feedback for our team further evaluation. 

Recommended Solution
#2
Options
2 Reply
Re:Smart action with switch as a client-Solution
2021-11-03 02:21:58 - last edited 2021-11-03 20:46:04

Hello @Yokushka 

Currently, in a smart action, 'Control with a Switch' only allow smart switch works as the trigger , not the client device like the bulb/ plug works as the trigger, thank you for your idea, I will forward your feedback for our team further evaluation. 

Recommended Solution
#2
Options
Re:Smart action with switch as a client
2021-11-03 12:22:45
Thank you, this is important if a smart client turned off directly and switch doesn't know about it and stays on.
#3
Options

Information

Helpful: 0

Views: 630

Replies: 2

Voters 0

No one has voted for it yet.