HS-110 Can not enable remote Control

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

HS-110 Can not enable remote Control

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
HS-110 Can not enable remote Control
HS-110 Can not enable remote Control
2021-07-10 22:53:33
Model: HS110  
Hardware Version: V1
Firmware Version: 1.2.5

Please see my post about my HS-110 smart plug, stuck on "local only" mode here:

https://community.tp-link.com/en/smart-home/forum/topic/269908

 

When I re-add the device after factory reset it could not update the firmware but the device is showed up under my Kasa devices home page again. When I go to device settings, there is a red exclamation mark next to Remote control and it is off. When I click on the switch to turn it on, I am getting a notification "failed another cmd is running" 

 

Something is real fishy here. Does this mean, after about 3 months use two years ago, this device went dud on me ? I have 3 other HS-110s purchased at the same time which do not have this issue. I am really pissed at TP-LINK brand at this moment.

  0      
  0      
#1
Options
1 Reply
Re:HS-110 Can not enable remote Control
2021-07-12 02:11:46

@The_Mel Hi, please check my reply here on your other post here and update firmware for HS110 V1.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 760

Replies: 1

Related Articles