NC200 Motion Detection. Big ISSUE !
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC200 Motion Detection. Big ISSUE !
Model : NC200
Hardware Version : Not Clear
Firmware Version : 2.1.7 Build 160315 Rel.27420
ISP : 3
TP-Link...(Please read)
I have 2 Nc200 now, and they are working fine beside the disconnection issue(still disconnects and having stream problems) :(
The Motion Detection. when it detects some motion, it captures 5 pictures, but there is an issue here
because it waits about 20 Seconds, before it recapures again, and in those 20 seconds, much can happen.
It could be nice IF THE CAMERA KEEPS CAPTURING, if it senses motion, and not wait x,x seconds between captures..
Please remove the 5 picture limit for motion detection, and give us motion detection when there is something moving in front of the NC200, if it requires 12 pictures to capture a movement. it should capture 12 pictures, and not just the start of it.
exampel: Cam1(Driveway) A small motorcycle drives by(took 4 pictures). me comming home(1 picture of me, ON the street, NO pictures captured of me driving in my own driveway, because of the delay)
I have set mine up to to 20 Seconds in "sending interval". if this is what gives those 10 to 15 seconds where there is no pictures captured, even if there is motion in front of the NC200, then we need a sending interval for 10 and 5 seconds !!
Warley
Hardware Version : Not Clear
Firmware Version : 2.1.7 Build 160315 Rel.27420
ISP : 3
TP-Link...(Please read)
I have 2 Nc200 now, and they are working fine beside the disconnection issue(still disconnects and having stream problems) :(
The Motion Detection. when it detects some motion, it captures 5 pictures, but there is an issue here
because it waits about 20 Seconds, before it recapures again, and in those 20 seconds, much can happen.
It could be nice IF THE CAMERA KEEPS CAPTURING, if it senses motion, and not wait x,x seconds between captures..
Please remove the 5 picture limit for motion detection, and give us motion detection when there is something moving in front of the NC200, if it requires 12 pictures to capture a movement. it should capture 12 pictures, and not just the start of it.
exampel: Cam1(Driveway) A small motorcycle drives by(took 4 pictures). me comming home(1 picture of me, ON the street, NO pictures captured of me driving in my own driveway, because of the delay)
I have set mine up to to 20 Seconds in "sending interval". if this is what gives those 10 to 15 seconds where there is no pictures captured, even if there is motion in front of the NC200, then we need a sending interval for 10 and 5 seconds !!
Warley
