C310 using AgentDVR has invalid source

2025-03-02 16:35:10 - last edited 2025-03-21 12:33:14

Posts: 24

Helpful: 0

Solutions: 2

Stories: 0

Registered: 2023-11-29

C310 using AgentDVR has invalid source

2025-03-02 16:35:10 - last edited 2025-03-21 12:33:14

Model: Tapo C310

Hardware Version: V1

Firmware Version: 1.13.16

My camera works OK with Tapo. But I'm trying to use it with AgentDVR I have teh camera setup as Onvif with(replacement for iSpy) using port 554 with camera usinga static ip LAN address. But the log shows as beloe with no pivideo streaming. I'm tr16:21:01	Tapo TP-Link C310: SourcePlayingFinished: Playing finished (DeviceLost)
16:21:01	Tapo TP-Link C310: NextReconnectTarget: Reconnecting in 30s
16:21:31	Tapo TP-Link C310: CheckReconnect: Reconnecting
16:21:31	Tapo TP-Link C310: EnableDevice: Enabled
16:21:31	Tapo TP-Link C310: SourceErrorHandler: CoreLogic.Sources.Combined.MediaStream:Invalid Source ()

1 Accepted Solution

2025-03-03 11:35:44 - last edited 2025-03-21 12:33:14

Posts: 15215

Helpful: 2655

Solutions: 2698

Stories: 8

Registered: 2020-05-19

Re:C310 using AgentDVR has invalid source-Solution

2025-03-03 11:35:44 - last edited 2025-03-21 12:33:14

Hi,
Typically, port 2020 is used for establishing the Onvif connection. You can refer to the instructions below to set up an RTSP/Onvif connection.
How to view Tapo camera on PC/NAS/NVR through RTSP/Onvif Protocol

If you are having trouble establishing the Onvif connection, please refer to the following instructions for troubleshooting:
What can I do if fail to stream the Tapo camera via the RTSP/ONVIF protocol?

Best Regards