Tapo D230 doorbell LED status light
I've just purchased this doorbell and set it up yesterday. If it works in a stable manner it will be great. I hope it settles down and does not have to be returned for a refund but it's becoming quite frustrating trying to get it to work properly.
I've read loads of stuff on here already and I'm pretty sure all my settings are correct but the doorbell will not operate consistently. Sometimes it is literally minutes later before my phone rings or receives a notification following a bell push even though the signal strength is good at -42 (RSSI) and even better on the hub. I've tried the hub wired and wireless with no difference. I get a message saying the network is unstable when replaying a video clip too (it idefinitely sn't unstable - the router is close by and all devices show full bars) yet the second time the video will play no problem.
My first question is should the green status light on the doorbell be solid 24/7 or does it go out when the bell is in battery saving/sleep mode? If the green light should be continuous even when the bell is in power saving/sleep mode then I guess mine is faulty as it seems to be off sometimes then comes on for a bit and goes off again. If someone could answer this question as a starting point that would be great.
Thanks in anticipation.