Using motion detection instead of person detection because failing

Using motion detection instead of person detection because failing

Using motion detection instead of person detection because failing
Using motion detection instead of person detection because failing
2024-05-19 17:12:57
Tags: #Motion Detection #person detection
Model: Tapo C210  
Hardware Version: V2
Firmware Version: 1.3.11

I've installed a couple moths ago a tapo c210 to the entrance of my house. I had only person detection for this camera, but I've seen, sometimes it did not notification when a person was in the entrance of my house, so I decided to add motion detection with low sensibility. Now it detects flies, flying bugs... Even though I have the lowest motion sensibility. Is there any solution? I dont want to miss a person in front of my cam, but some days I get 4 or 5 flying bug notifications in an hour... it is a bit disgusting

 

Video: https://youtube.com/shorts/dhcd4FHJ6_I?feature=share

 

Another question, has the Tapo c220 better person detection than the tapo c210? 

Thanks

  0      
  0      
#1
Options
1 Reply
Re:Using motion detection instead of person detection because failing
2024-05-20 11:37:58

  @ercovi 

Hi,
In this situation, enabling motion detection is not a solution, and please help confirm the following information for further analysis.
1. What sensitivity value have you configured for the person detection feature?

 

2. Can you share a picture showing the position you installed the Tapo C210?

 

3. Would you please share a video showing there is a person but not detected by the Tapo C210?

 

Btw, the person detection feature is almost the same on the Tapo C210 and C220.

 

Best Regards

  0  
  0  
#2
Options