Only one of three gets the new FW 1.2.1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have three C510W with same HW Version but only one has the new FW 1.2.1
The other two says FW is the newest but it is 1.1.2.
What can i do to update these both to 1.2.1?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@PixelPaladin @JN2day
Hi,
You can refer to the Q3 in the instructions below to see the answer to the reported case.
Common questions about the TP-Link camera's firmware
Since we roll out the new firmware gradually, it's reasonable to see that some cameras detect and update to the new firmware, but some do not. Please wait patiently, and when the new firmware is pushed to your other cameras, you can update the firmware via the Tapo app.
Best Regards
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@PixelPaladin but why hast one Kamera Version 1.2.1?
- Copy Link
- Report Inappropriate Content
@PixelPaladin @JN2day
Hi,
You can refer to the Q3 in the instructions below to see the answer to the reported case.
Common questions about the TP-Link camera's firmware
Since we roll out the new firmware gradually, it's reasonable to see that some cameras detect and update to the new firmware, but some do not. Please wait patiently, and when the new firmware is pushed to your other cameras, you can update the firmware via the Tapo app.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 555
Replies: 3
Voters 0
No one has voted for it yet.