Firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Firmware
Firmware
2023-12-11 19:08:38 - last edited 2023-12-22 02:31:56
Model: Tapo C200  
Hardware Version: V1
Firmware Version: 1.3.6

hi, probably when the camera was updating, I turned off the power. Now I can't connect to the camera. The infrared LEDs are on. Can I install firmware via SD card? If so, please provide both the file and instructions.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Firmware-Solution
2023-12-12 11:15:11 - last edited 2023-12-22 02:31:56

  @kecaJ002 

Hi,
You can refer to the instructions below to check if it will help for your case.
What to do if my Tapo Camera gets bricked after a firmware update?

Best Regards

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Firmware-Solution
2023-12-12 11:15:11 - last edited 2023-12-22 02:31:56

  @kecaJ002 

Hi,
You can refer to the instructions below to check if it will help for your case.
What to do if my Tapo Camera gets bricked after a firmware update?

Best Regards

Recommended Solution
  0  
  0  
#2
Options