Hi!

I added an Automation routine to the Tapo App. When the measured temperature of the T310 sensor goes below 19°C it powers the swittch P115 on. And a second automation routine, which switches off the P115 when the temerature reaches 20°C.

Its working fine, but the histeresis of 1°C is too much. Also the switching temperature should be between 18 and 19°C, but the slider does not allow to set only whole numbers. Could you please change the slider to numerical input with one decimal, so we can add also numbers like 18.7°C, 18.8°C, etc? 

Thanks!