False Detection Recordings and Alerts
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hey,
I'm trying the performance of C310 V1 FW 1.1.12 pointing to a street. I'm getting a lot of false alerts and recordings, wasting sd memory space with no relevant recording.
What I tried:
1) Changing Motion Detect Area excluding no interest area. Detection Level to Low.
No luck. 
2) Motion Detect Off. Trying only Area Intrusion and adding just a small area for test
No luck.
Example:
Can this camera avoid this?
Update:
1) After disabling AI Detection now the camera works much better, minimizing falses detections and imrpoving the perfomance a lot. Now more than 95% of videos have recordings as expected:
Test Configuration: Only Area Intrusion is Enabled
With the following result videos:
These are much closer to what I was expecting.
But there are a lot of different videos with the same miniature like this (I'm using Tapo_Trial 16):
And this:
2) When an Area Intrusion is triggered some of recorded videos has "latency" or it is delayed like the following examples:
Test Detection Areas:
Some videos with delayed detection:
Some videos with good detection:
This delay can cause a fast source that triggers an Area Intrusion to not show up on the recording as sometimes happens when a car drives over the yellow perimeter on the street. Those are the 5% of the videos.
Ok. After some hours testing I have more than 400 videos, 40% of them are real area intrusion, 60% are false triggers. I tested Cross Line feature with the same poor results. It seems that this C310 model it is not suitable for this 
Too bad because I had thought to have only Tapo cameras and only one app in my phone.
Any comment or suggestion would be appreciated.
Thanks.
Update:
1) After disabling AI Detection now the camera works much better, minimizing falses detections and imrpoving the perfomance a lot. Now more than 95% of videos have recordings as expected:
Test Configuration: Only Area Intrusion is Enabled
With the following result videos:
These are much closer to what I was expecting.
But there are a lot of different videos with the same miniature like this (I'm using Tapo_Trial 16):
And this:
2) When an Area Intrusion is triggered some of recorded videos has "latency" or it is delayed like the following examples:
Test Detection Areas:
Some videos with delayed detection:
Some videos with good detection:
This delay can cause a fast source that triggers an Area Intrusion to not show up on the recording as sometimes happens when a car drives over the yellow perimeter on the street. Those are the 5% of the videos.
