This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.PTZ - (Pan & Tilt) Feature [C200 C210 C500 C510]
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Request for the following PTZ (Pan&Tilt) Features:
1. Cruise/Patrol to Marked Positions
2. Limiter/Defined Mark for Panning Vertically and Horizontally
This will make the PTZ more efficient to use.
- Better if time intervals can be configured
- Random Positions to visit is also good
Hi All,
1. Currently, some Tapo camera models, such as Tapo C225, C500, etc., support configuring the Patrol Mode on the camera's Device Settings>Pan & Tilt>Patrol Mode page. Below are the steps to set up the Patrol Mode feature.
Note: Non-stop patrolling may affect the motor life of your camera.
1) Tap Add Mark on the Patrol mode page, tap the arrow on the steering wheel to select a desired viewpoint, and click on Add Mark.
2) Customize the Mark Name, select Layover Time, and tap Save to save the settings.
3) Repeat Steps 1) and 2) to add two or more marks, enable Patrol Mode, tap Patrol Mode Schedule to set a schedule to turn on the Patrol Mode, and then the camera will move between your marked positions.
2. For the feature to limit the maximum movement position of the camera in the vertical and horizontal directions, it's recommended to vote or leave your comments on the thread "Limit movement".
Best Regards
