HS110 does not display Energy usage and randomly power cycles
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Just the same as Ive seen a ridiculous amount of other people reporting, my HS110 no longer reports/displays any power usage. Its been this way for some time (maybe over a year) but I know it was after the firmware was updated to its current version that the issue presented itself (just the same as everyone else has said). It will also periodically power cycle on/off (the time frame on-off is approximately half a second), the device will then have to reconnect itself to the wifi. This happens no matter what power source its connected to and makes no difference if there is even anything attached to draw power.
Am hoping there is some 'magic wand' solution for this .
Cheers,,
Hi, currently a 25W soldering iron is attached,.As far as the power cycling goes, the issue has occurred at 2 different wifi locations (connecting to different wifi base stations. When the power cycle occurs, the device does a full reboot and reconnect to the wifi. .
The log as requested...
{"smartlife.common.debug":{"get_all_log":{"log":" [I][20000102110145]over flow occurs
[I][20000102110148]connected to AP *******
[I][20000102110154]Start hello cloud
[I][20000102110156]Start hello cloud
[I][20000102110156]Hello cloud success
[I][20000102110157]cloud_account state change: from 0 to 4
[I][20000102110157]get_time: 2021-9-25 22:54:10
[I][20210926085410]checkBindStatus
[I][20210926085410]cloud_account state change: from 4 to 5
"}}} {
"smartlife.common.debug": {
"get_diagnose_status": {
"lrrt": 0,
"deviceId": "8006B6ABFE418B150BAD74E942AB3B0C19D0F3D4",
"max_reconnect_time": 6,
"htc_put": 0,
"disconnect_cnt": 0,
"htc_get": 22,
"mac_cnt": 8,
"mac_reap": 0,
"htc_cnt": 3,
"htc_reap": 0,
"bid": "20B00137FB9B",
"lrr": 0,
"Heapsize": 292212,
"free_cnt": 8,
"rr2": 0,
"rr1": 0,
"fw_reap": 0,
"alias": "Smart Plug",
"fw_cnt": 1,
"rssi": -28,
"runtime": 66,
"err_code": 0
}
}
}{
"emeter": {
"get_dev_info": {
"err_code": 0,
"device_id": "0xffffffff"
}
}
}{
"emeter": {
"get_vgain_igain": {
"igain": 15839,
"vgain": 13279,
"err_code": 0
}
}
}{
"emeter": {
"get_realtime": {
"total_wh": -1,
"current_ma": 291751,
"power_mw": 0,
"voltage_mv": 970801,
"err_code": 0
}
}
}
This is usage while the attached soldering iron is turned on (or off, it doesnt matter which, it remains the same)
