@Doesitmatter

@Doesitmatter 

Hello,

Have you got any idea what I could try to add the C200 to my NVR.

User account is created and enabled with the app, the video stream can be viewed without any problem on VLC (with RTSP)

but no luck with the NVR. The camera is detected by the NVR, that's it.

These are my settings. Thank you very much!

@Matt81 

What NVR is it?

If it works in VLC, then it's got to be an issue with with NVR config.

@yusufkilinc 

Hopefully you got this working alfready, but all I can see is instead of "Channel 1" you have "Stream 1" in 1st image.

TBH, I'd be surprised if that makes the difference.

I have been able to connect to all my c200 cameras using NVR but the issue is everytime the camera boots the ip address changes.

I tried to map the mac to IP on my router, but then I noticed the IP changes because with reboot the cameras Mac also changes.

Hence even though I have been able to connect the NVR and cameras is not very reliable because everytime the power fails or someone accidently switched off the camera and reboots the NVR loses connection

@ChetanSen You need to set static or reserved IP for the camera on your router of whatever issues DHCP addresses.

It will always issue the same one then.

@Doesitmatter 

Thats what I am trying to say. To reserve a static address for any device, you bind the IP to the mac address of that device. Problem with these TP cameras are everytime they reboot the mac address changes ( which goes against the whole point of having a mac address), hence even if the static address was reserved for the camera, when it boots it requests for a new DHCP address using the new mac address

@ChetanSen I don't see that with mine. It reboots at 3am every day and no ip issues.

@Doesitmatter  No matter which software I try I always get the message "Authorisation Failed" or some variation of those words. The camera works great (only had it 3 days) but I REALLY would like to be able to see its stream on my desktop PC.