Smart Home Community > Tapo Smart Camera > NC200 fails after updating it.
< Tapo Smart Camera

NC200 fails after updating it.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NC200 fails after updating it.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC200 fails after updating it.
NC200 fails after updating it.
2018-02-23 04:11:52
Model :

Hardware Version :

Firmware Version :

ISP :

Greetings comrades, I have an NC200, after updating it with an android application it was left in red bulb, and no matter how long the reset button was pressed, then I connected it to the computer and it came out, you recognize it but it does not show me the data just shows the MAC information, and the other cups like the IP come out empty,

someone knows how to mount the firmware back to the NC200 through a computer.
  0      
 
  0      
 
#1
Options
8 Reply
Re:NC200 fails after updating it.
2018-02-25 21:28:45
Thanks.
  0  
  0  
#2
Options
Re:NC200 fails after updating it.
2018-03-05 15:02:43
If the camera has a red light, and it did not respond to reset, it's probably faulty.
  0  
  0  
#3
Options
Re:NC200 fails after updating it.
2018-03-06 00:32:56
I already did everything, with the computer program and Android and it does not work, I even wrote to technical support, for the defective update and could not be anything because it is from Colombia or even an additional formatting program, simply tp-link no It gives me guarantee of nothing for damage caused by them.
  0  
  0  
#4
Options
Re:NC200 fails after updating it.
2018-03-06 14:49:16
Additional formatting program? You are not using tpcamera app to update? If you did the update go by the book, that would not void warranty I think.
  0  
  0  
#5
Options
Re:NC200 fails after updating it.
2018-03-07 00:08:46
mate, when updating says, connect the camera to the network cable and through the update program, I did it literally, and it stayed in red bulb and the reset button does not work.
  0  
  0  
#6
Options
Re:NC200 fails after updating it.
2018-03-07 17:00:52
any power outage or anyting happened during the firmware update?As far as I know., if any power outage , it will damage the camera. Did you see 100% after the firmeware update
  0  
  0  
#7
Options
Re:NC200 fails after updating it.
2018-04-07 00:51:48
Did you solve this? I have the same problem! Red light flickering after a failed firmware upgrade
  0  
  0  
#8
Options
Re:NC200 fails after updating it.
2018-04-10 12:46:53

Reslep67 wrote

Did you solve this? I have the same problem! Red light flickering after a failed firmware upgrade
there was no solution, according to the tp-link the problem is yours and not theirs, I finished it bouncing because there is no fix.
  0  
  0  
#9
Options

Information

Helpful: 0

Views: 907

Replies: 8

Related Articles
Camaras NC200
689 0
 Nc200
654 0
 How do NC200 Internet
851 0
 Nc220 / nc200
766 0
 NC200 Chrome
819 0
Firmware not updating
1117 1
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.