ER605 IPSec VPN Site to Site Client Communication
Hello All,
I am a beginner in networking and currently I have the below setup.
To give a overview of the setup, I have 2 sites (Site A and Site B 2 different locations). Both sites have ER605 VPN router which is connected to WAN and an IPSec VPN tunnel has been established between them. Each site has a Wi-Fi router (Archer AX73) whose WAN port is connected to LAN port of the VPN router. I have few clients connected to the Wi-Fi router via Wireless and Wired. This setup is similar on both the sites.
IPSec VPN tunnel has been created with LAN IP of the VPN router as the Remote Subnets.
Connecting to LAN IP of the VPN router from clients in both sites works fine. Now my requirement is to connect to a client in Site B which has a IP address of 192.168.6.3 from a client in Site A which has a IP address of 192.168.5.10. How to access LAN IP of Wi-Fi router of Site B from a client in Site A and vice versa? Hope my requirement is clearly understandable. Kindly let me know whether it is achievable and if yes what needs to be done to get this working. Thanking you.
I bet he's doing that to have the WiFi, cuz ER605 doesn't have built in WiFi module...
The easiest way would be to replace the Archer with TP-Link (or any other) Access Point.
But I guess it could be possible to configure, as I check, the Archer supports Static Routing:
Here's more info of how to set up routing on that router:
