pets
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi. I need to adjust the sensitivity of a T100 to exclude the presence of two cats of about 7 kg that move freely even climbing on armchairs and tables. It would be great not to have to change the installation angle of the sensor but only the sensitivity. Is it possible? Thamk you
The detection sensitivity of the sensor can be adjusted ( App Sensor Device Settings -> Motion Sensitivity.), three options are available, low for 3m, normal for 5m and high for 7m. It is more about the detection range.
However, for pets like cats and dogs, the heat changes they produce are quite significant, so adjusting the sensitivity may not have much effect. It is recommended to adjust the installation angle of the sensor instead.
Tapo T100 sensor's detection angle is 120°, you may refer to the below picture to adjust the location.
The detection sensitivity of the sensor can be adjusted ( App Sensor Device Settings -> Motion Sensitivity.), three options are available, low for 3m, normal for 5m and high for 7m. It is more about the detection range.
However, for pets like cats and dogs, the heat changes they produce are quite significant, so adjusting the sensitivity may not have much effect. It is recommended to adjust the installation angle of the sensor instead.
Tapo T100 sensor's detection angle is 120°, you may refer to the below picture to adjust the location.