how to make switch profile without a Native VLAN with controller?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

how to make switch profile without a Native VLAN with controller?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

mbze430

2024-05-29 13:04:14

Posts: 51

Helpful: 8

Solutions: 2

Stories: 0

Registered: 2019-04-20

how to make switch profile without a Native VLAN with controller?

2024-05-29 13:04:14

Tags: #VLAN & Multi-Networks

Model: Omada Software Controller (Linux)

Hardware Version: V5

Firmware Version: 5.13.30.8

In the drop down menu there is NONE but it's always greyed out

How can I make a profile without the native vlan??

For example below I am trying to make a all tagged trunk, 254,1128,52,170 that will communicate with an EAP773

e216c875d03d4ec2b7beaeae12817df6

1 Reply

Hank21

2024-05-30 03:30:40

Posts: 3673

Helpful: 719

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:how to make switch profile without a Native VLAN with controller?

2024-05-30 03:30:40

Hi @mbze430

It doesn't support no native VLAN in controller mode currently. If you do want to have a profile without untage network/native VLAN, you can try to create a switch only VLAN with a random VLAN ID but neither gateway nor switch has the port using this VLAN.
Please note that you have to enable the management VLAN for your EAP prior to adding this random VLAN, or you will fail to maange the EAP.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

how to make switch profile without a Native VLAN with controller?

how to make switch profile without a Native VLAN with controller?

Information

Voters 0

Tags