Can't access EAP225 on Vlan. But AP is functional

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Can't access EAP225 on Vlan. But AP is functional

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

tpen1

2023-06-17 08:41:47 - last edited 2023-06-17 08:44:26

Posts: 1

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2023-04-16

Can't access EAP225 on Vlan. But AP is functional

2023-06-17 08:41:47 - last edited 2023-06-17 08:44:26

Tags: #VLAN & Multi-Networks

Model: EAP225-Outdoor

Hardware Version: V3

Firmware Version: latest

Hello Community,

My EAP-225 has an IP address of 192.168.25.2 and a subnet of 192.168.25.x. I VLAN-tagged 5ghz as 192.168.27.x and VLAN-tagged 2.4ghz as 192.168.28.x for my IOT's.

I accidentally changed the DNS setting (or gateway) of the EAP-225 to 192.168.27.1 instead of 192.168.25.1. Since then, I can't seem to access the 192.168.25.2 gui from anywhere on the lan. But the EAP-225 AP is functioning well.

I can ping the IP from my opnsense router, though.

Please help.

Thanks.

1 Reply

d0ugmac1

LV5

2023-06-17 13:03:27

Posts: 2113

Helpful: 771

Solutions: 191

Stories: 0

Registered: 2022-03-05

Re:Can't access EAP225 on Vlan. But AP is functional

2023-06-17 13:03:27

@tpen1

Probably easiest to just factory default the AP and start over. If you can join your laptop to the same subnet/VLAN as the AP then you can likely log in (since gateway not needed) and make the change that way too.

<< Paying it forward, one juicy problem at a time... >>

Can't access EAP225 on Vlan. But AP is functional

Can't access EAP225 on Vlan. But AP is functional

Information

Voters 0

Tags