Downlink APs not connecting to Root AP after power cycle/power outage
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Setup
-
ER605 v2.0
-
TL-SG3428MP
-
OC-200
-
EAP245(US) x 3 [Namely, ControlRoom Access Point {C.AP}, Shop Access Point {S.AP}, Lobby Access Point {L.AP}]
-
EAP225(US) [RoofTop Access Point { RT.AP}]
Map
The three access points [RT.AP, S.AP, and L.AP] are connected wirelessly in mesh mode
Problem
After a power outage, the three Downlink APs do not connect back to the Root AP (C.AP) [Image below] after a power outage/cut. To connect them again, I have to manually remove them from the Controller and go to each of them to perform a physical reset, and again add them to the controller.
Before Power Outage
After Power Outage
Note
I cannot run an Ethernet cable to each of the Access Points currently, I am planning to do so in the near future.
Hi, did you enable Auto Failover? What is the firmware version of your OC200?
You can also try exchanging the mesh AP and the root AP for testing.
And don't put the mesh APs too far away from the root ap.