EAP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello Community
Has anyone encountered this kind of issue?
Picture 1
Picture 2
Please note that the EAP of picture 2 is in a different building that no interferences an open office with no glass
what could be the reason for this and what is the solution the EAP is updated
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hey
In short, thats 2,4ghz for you! It could well be a bug in the firmware, but honestly its likely just congestion on the airspace, seen it a thousand times. Sadly 2.4 can be interfered by virtually anything, not specifically WiFi. Channel 1 is a known issue as its in the Zigbee range so that interferes. Bluetooth is also around there somewhere.
In short, if seeing that on channel 1, go to 6 and retry. It may be worse or better, it aint sadly going to disappear. In virtually all installations 2.4ghz is totally flooded and should be avoided where possible. 5ghz is usually fine, which it appears so in both your pictures.
More info below, this has been asked load of times on the forums.
https://community.tp-link.com/en/business/forum/topic/572536?replyId=1114078
- Copy Link
- Report Inappropriate Content
The difference is simple, the lower AP does not break out the 'BUSY' information like the upper one does. In other words
RX+TX+INTERFERENCE == BUSY
Also the difference between 30% and 40% utilization is not that significant. If it still looks like that at 3AM...maybe there's something else broadcasting on that frequency that's not part of your network...like a Chromecast, or Wifi Printer, Security cam....
- Copy Link
- Report Inappropriate Content
If you are still confused, maybe this solution post can help you:
EAP225 v5 only showing Busy and Free while EAP225 v4 shows RX / TX Frames, Interference & Free
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 401
Replies: 3
Voters 0
No one has voted for it yet.