MAC address map / loop detecting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Greeting!
Where and how can I check which MAC addresses are found on which port on a specific switch?
Do I know, and where, that only a given MAC address is accepted on a given port?
Also, where can I set it so that if it detects a loop, it only disables the two ports where it detects it, but the whole system doesn't crash!?
Thanks!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@pparta Witch switches are in use?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@pparta I would make some Switch ACL rules on those custom ports configured with MAC groups. Could this be a solution?
You see MACs if you open the switch on controller and look for the clients.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Oh I know this. It's not supported by the controller. However you can do it in Standalone mode, it's called static MAC address.
"After you have added the static MAC address, if the corresponding port number of the MAC address is not correct, or the connected port (or the device) has been changed, the switch cannot forward the packets correctly. "
You can refer to the User Guide for more details.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 808
Replies: 6
Voters 0
No one has voted for it yet.