EAP225-Outdoor Mesh
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dear Support
If i buy 3 units of EAP-225-Outdoor and connect all of them with network cable to my switch(same switch) individually, will mesh functionality still workable/configurable ?
Please advise. Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
You can do that, but if you want to use the mesh functionality you'll need an Omada controller as well - FAQ - Q3.
If you don't have Omada controller, the APs would be in standalone mode - see the difference - Q3.
Here's an example building mesh network with Omada EAP at home.
- Copy Link
- Report Inappropriate Content
Wonderful details, thank you so much.
I believe i could use the "software Omada Controller" instead of a hardware version(OC200) right?
Another question would be on my switch and router, both my current switch and router are Dlink product, do I need to replace them with TPLink product as well?
If yes, what type of TPLink router is needed for the mesh functionality to work(must it have One Mesh functionality as well)?
Please advise.
Thanks again.
- Copy Link
- Report Inappropriate Content
Yes, you can use the controller software instead of the hardware version.
I believe that the mesh network will work with your existing equipment, just you won't be able to configure and manage your gateway(router) and switch with the controller.
See Omada SDN FAQ - Q2,Q5 and Q8.
OneMesh is different technology and that's not needed for building Omada EAP mesh network.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 863
Replies: 4
Voters 0
No one has voted for it yet.