Routers and SDN and one-to-one nat
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
hello,
I want to start using the ER7206 (TL-ER7206)
but the routed subnet function is not included so I want to replace it with one-to-one nat.
unfortunately I can't record it in the controller right now, I hope that will be solved in the future.
but the one-to-one nat function does not work in this router
I configured the wan static
and go through the short steps of the manual so ready
but no effect can be seen of this option
do you have any suggestions?
with a warm greeting from the Netherlands
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Thie-nzod,
Thie-nzod wrote
but the one-to-one nat function does not work in this router
I configured the wan staticand go through the short steps of the manual so ready
but no effect can be seen of this option
do you have any suggestions?
Please refer to this guide to configure the One-to-One NAT function in Standalone mode.
Kind note: On TP-Link routers, One-to-One NAT (Network Address Translation) creates a one-to-one mapping between a valid public IP address and a private IP address of a local host. It is mainly used when there are two or more available public IPs used on the same WAN port. And it only takes effect when the connection type of the corresponding WAN port is Static IP.
- Copy Link
- Report Inappropriate Content
My config
Wan:
static
ipadres xxx.100.35.26
subnet 255.255.255.248
gateway xxx.100.35.25
one to one
192.168.1.52 - xxx.100.35.27
192.168.1.76 - xxx.100.35.28
192.168.1.22 - xxx.100.35.29
192.168.1.15 -xxx.100.35.30
it have no working at al
a read the manual in front
- Copy Link
- Report Inappropriate Content
Yes I Wonder the same thing. I have a bunch of public ip but can only use one public ip in router. so have to portnat but i cant portnat mutch before conflict on ports with only one ip adress to work with..
So TP-LINK pls add this option.
One to One and Port NAT from multiple public ip.
/shberge
- Copy Link
- Report Inappropriate Content
Dear @Thie-nzod,
Thie-nzod wrote
it have no working at al
a read the manual in front
For your case, I'd like to escalate to the TP-Link support team who could help you more efficiently.
They will reach you via your registered email address shortly, please pay attention to your email box later.
Once the issue is addressed or resolved, I'd encourage you to share it with the community.
Thank you so much for your cooperation and support!
- Copy Link
- Report Inappropriate Content
It's very quiet on the side of tp link
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1299
Replies: 6
Voters 0
No one has voted for it yet.