HS220 - Dimmer - Switch powers on but the Lights dosn't turn on
So just replaced an existing Dimmer switch with TP Link HS220.
Managed to get the Switch itself to power on but the 10 potlights dont turn on. Very Odd since they turned on with the dumb dimmer switch.
Now could this be a defective unit? Please help!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@B.Will I only took after pictures.
- Copy Link
- Report Inappropriate Content
Wiring looks correct.
You can try swapping the leads.
Put the 3 black wires on the black screw, and the one black wire on the red screw.
- Copy Link
- Report Inappropriate Content
@B.Will Thanks, will try that tonight.
I just want to be clear, the switch itself has power right now with this setup.
- Copy Link
- Report Inappropriate Content
Swapping them should not cause any problem.
- Copy Link
- Report Inappropriate Content
Below is the setup video of the HS220.
https://www.tp-link.com/support/download/hs220/#video
Please ensure that the difference between live screw and load screw.
Note: The live screw is for live wire only, load screw for load wire only.
May it help.
- Copy Link
- Report Inappropriate Content
@B.Will I swapped them but then the switch wont even turn on.. do you think the switch is defective?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Please ensure that the hardware installation is correct; if still the same -- switch cannot be turned on, you can contact the retailer to change a new one to give it a go.
While if the new switch still does not work, you may need check the wall outlets/electrical wires.
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3368
Replies: 9
Voters 0
No one has voted for it yet.