T2600G-18TS - Save & Restore Manual Binding (DHCP)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hardware Version :
Firmware Version :
ISP :
Hello everybody,
I've spent 1 hour to insert manually my DHCP binding reservations (DHCP Server -> Manual Binding), saved through Save Config link, power down and up and they disappeared.
Ok, re-spent another hour to re-insert them, saved configuration by System Tools -> Config Backup and ok, the bindings are in the cfg file.
Power down and up again, restored the configuration (through System Tools -> Config Restore) and NOTHING!!!!
How can I save my DHCP Server manual bindings?!?!? (through MAC address)
Thanks,
Fabrizio
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hello Fabrizio,
It is already some time ago you issued this problem at this forum. So do not know if you got a resolution.
I have a T1600G-28PS and exactly the same problem...
Already contacted custom support who confirmed they need to do a test on the same hardware platform.
Where you able to solve this issue?
I think (hope) it is a small logical issue.
Would appreciate your feedback
Best Regards,
Ernest
- Copy Link
- Report Inappropriate Content
Same problem here with T1600G-28TS 3.0 ... Dhcp manual binding disapear after reboot
- Copy Link
- Report Inappropriate Content
Same problem here too
someone have any solution ?
- Copy Link
- Report Inappropriate Content
Rev wrote
Same problem here too
someone have any solution ?
If you are using T2600G-18TS V1, you can try to upgrade the firmware to V2. V1 can use the firmware of V2. But you may lost the configuration after upgrade to V2.
- Copy Link
- Report Inappropriate Content
thank you for you reply, i have v3 :(
- Copy Link
- Report Inappropriate Content
Rev wrote
thank you for you reply, i have v3 :(
There is no V3 version for T2600G-18TS. Check the sticker on the bottom of your device.
- Copy Link
- Report Inappropriate Content
Hi Rev
Please check the version of T2600-18TS not TL-SG3216. Then try to upgrade the latest firmware (v2). If the latest firmware still has the issue, we suggest to contact TP-Link Support.
- Copy Link
- Report Inappropriate Content
sorry i made some confusion, my switch is a T1600G 28TS v3 but have the same error like t2600
- Copy Link
- Report Inappropriate Content
Hi Rev
T1600G-28TS V3 will release the new firmware soon. It should hasn't this issue. You can pay attention to the official website. Wait for the new firmware.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2085
Replies: 10
Voters 0
No one has voted for it yet.