Hello, Goal: I want to allow only specific host addresses to be able to access specific ports opened up by NAT. My device is in stand-alone mode, and I have some ports that are setup under NAT->Virtua

Hello, To better utilize the TPLink Omada line of routers to fit within the business models, I'm wanting to be able to funnel traffic, either full or split, to specific locations that are interconnect

Hello Gurus, I'm trying to setup a small ring between 3 sites with 3 ER605s connected to a single ISP at each site. I have the VPN tunnels established and can reach the subnets at each site from the o

Hello, I have an IPSEC connection setup between a ER7206 & ER605 in the following design. ER7206 (Hub) <-> ER605 (Spoke) Connections work fine to each other to the primary LAN over the IPSEC connectio

Is it possible to restrict inbound NAT rules by TOD? I want to only allow certain NAT's during certain hours. I can't seem to figure out how to tie a Time Range profile to the NAT configuration, if th

It is very painfull to setup good ACL rules without an "Established and Related" traffic option. Here is another thread about this request : https://community.tp-link.com/en/business/forum/topic/25286