@Somnus Unfortunately it appears that my switch T2600G-28TS 3.0 is not supported by Omada Controller? On further reading...

@Somnus Yes dual connections used - CCR's have BGP from ISP, Setup OSPF on both CCR's which each have a full routing table ! Vlan's used for Management + PPPoE from Radius Server I contacted TP-Link...

@Tedd404 Apologies for the vague question? Just recently I had this switch connected to two Routers (Mikrotik CCR's) in a manual load balanced configuration, if for example the total VLAN count was...

Model : T2600G-28TS Firmware Version: 3.0.0 Build 20180201 Rel.73119(s) Serial Number: 2185341000155 Can I ask for advice on solving a VLAN loop? Kind Regards, James

Is it possible to have a second MSTP on the switch - currently port 7 (int-cost 100, ext-cost 100, port role=root port status=forwarding ) + port 8 (int-cost 400, ext-cost 400 port-role=alternate...