@MR.S Saw that in a couple of threads, the only thing is that I don't know if this will come in standalone mode as well since that's how I'm intending to run all the routers. Thanks for the info!

@MR.S Hey thanks for the reply. Indeed, I was under the impression that a simple route in the routing table would solve everything. Following the article and pointing out the subnets did the job. I...

Hey all, So I'm currently trying to setup our own VPN between branches in order to move away from the one provided by the ISP. We managed to get 4 x ER7412-M2 and we were able to setup the IPsec...

So the documentation for the AX55 is dumb. The tunnel works but I had to enable a specific client on the AX55 to access the VPN -.-" That's why I couldn't establish the connection. All good, for the...

Already disabled FW in both clients. The thing I noticed is that from R1 I can ping R2 subnet, but not the R2 WG interface, why would that be?

@Clive_A Hey again, Tried with different WG interfaces IP, the tunnel doesn't go up. Managed to get to work and have access to both routers and based on that guide I did the following: R1 WG:...