itkairosLV1Online
Following: 0Followers: 0
Forums/ Controllers
2 weeks ago
Re:I don't want to assign ipv6. What should I do?
@Vincent-TP I want to disable IPv6 in my router settings so that clients don't use ipv6. I'm currently disabling ipv6 as shown in the picture below. Is this the only way? thank you
0HELPFULS
Forums/ Controllers
3 weeks ago
I don't want to assign ipv6. What should I do?
Hi I am using a controller installed on Linux. I have disabled ipv6. But the client is getting ipv6. I don't want to assign ipv6. What should I do? I have many routers connected to my controller,...
0HELPFULS
Forums/ Routers
2024-09-13 01:20:06
Re:I want to know how to disable lan ipv6.
@Clive_A I have the controller installed on linux and running the equipment and as of today all are up to date. And ipv6 setting is already disabled. But ipv6 client is being looked up.
0HELPFULS
Forums/ Routers
2024-09-12 14:18:10
I want to know how to disable lan ipv6.
I want to know how to disable lan ipv6. Currently, this is handled by unchecking the box in the Windows network adapter settings, but if there are a lot of computers, it takes a long time and is...
0HELPFULS
Forums/ WiFi
2024-08-24 07:48:33
Re: 5G tx-frame/rx-frame rate was displayed very high.
@itkairos I am operating with the equipment configuration below in conjunction with the Omada controller, but recently, there is a problem with poor wifi quality. ER707M2, SG3452(main), SG3428,...
0HELPFULS
Forums/ WiFi
2024-08-24 07:44:34
Re: 5G tx-frame/rx-frame rate was displayed very high.
@Vincent-TP The wifi quality is bad again. I think I was mistaken that it was good because the client was disconnected all over while adjusting the tx value etc. I am still frustrated and want to...
0HELPFULS