@Clive_A route 10.54.XX.0 255.255.255.0 In my application this openvpn client connection is intended to only route traffic to the server side subnet: 10.54.XX.0 similar to client-to-site business VPN...

I thought it might also be helpful to post the top lines of my .ovpn file in case tp-link requires additional lines or has issues with some of these? client dev tun proto udp remote 198.53.XXX.XXX...

I'm sorry I included the incorrect reference link. I meant to refer to this: https://www.tp-link.com/ca/support/faq/3631/ I am quite familiar with OpenVPN client / server setups. This OpenVPN server...

I should also mention that I am trying to configure this router standalone with no Omada Controller access. I do not have the same options noted in this how-to:...

I have a baffling challenge: I am trying to setup an ER7206 router with two active WAN connections in a 50/50 load balance design. The second WAN (WAN/LAN1) is chosen for an OpenVPN client link to a...

Hi, Can anyone advise if there is a method to use policy based routing for traffic routing through an OpenVPN tun0 interface? In my situation I have two active WAN interfaces in a load balancing...