Hello Team, Are there any plans to support Gateway QOS and DPI Application Control over IPV6. Currently, even though we can configure rules using ipv4, ipv6 groups into different classes via Gateway...

Finally, it worked Omada/ISP router: SLAAC + DHCP Deco: Bridge mode (reboot required). Thanks for you support everyone.

@David-TP yes I tried all options including bridge with no result. Thank you for the response.

Hello, I am unable to configure IPV6 on my deco. I have a omada system sitting in between my isp modem and deco. On omada system (router + switch + Controller), i get ipv6 assigned from ISP. However,...

@Clive_A Thank you for the response. I have figured this out by discussing with my ISP. They support only 56, 64 Prefix Size. So after reconfiguring it, now it works. So, this is no longer an issue.

@Clive_A Are the Ipv6 LAN prefixes other than 0 supported in this release? I see this not working in 2.2.2 Lets say, WAN: If I enable IPV6 in WAN and select Dynamic IP (SLAAC + DHCPV6) via DHCPV6 ->...