@Vincent-TP I already have the power level set to auto, I will try going to a fixed level. I'm concerned it will knock offline other AP's though, or limit the throughput if I lower the power. The...

Is there a way to force a device to connect to the network via wireless mesh vs. ethernet? Here's the situation: Internet ---> Root AP ))))) wireless mesh link ))))) Remote AP ---> ethernet switch...

@Vincent-TP I understand the basics, but the issue here is that vital information, like interface errors, timeouts, etc... are not being provided in the logs or through the interface. I could spend...

I have a bunch of outdoor and indor EAP's and from time to time I get random messages that an EAP was isolated/disconnected from the controller (OC200), and then minutes later it's re-connected. Some...

@Vincent-TP When I select Open WebUI from Pharos Control, or I try to go to the devices IP address directly the connection just times out. All I had done was install PharosControl and make the...

@Vincent-TP The CPE was configured, accessible via it's web interface and working fine prior to trying out the ParOS Control Software. Once the PharOS control software discovered the CPE, it could no...